HP Advanced Services zl Module with Citrix XenServer™ Platform Quick StartGuide

2-4

Getting Started

The CLI opens with information that contains the Primary Management

Interface IP address, if set by a DHCP server on your network when the

module was installed. If no DHCP server is found, the message IP address

not configured appears.

2. Login using the default credentials, root and P@ssw0rd.

Note Note that in the password, a has been replaced with @ and o has been replaced

with the digit 0.

3. Information on how to access the XSconsole is provided before the

command line is presented for use, as shown below.

4. Typing exit closes the xe CLI and logs you out. Type Control-z to return to

the switch CLI.

Important Typing Control-z while logged on the xe CLI keeps the session active, allowing

another user to access the xe CLI without authenticating. HP recommends

typing exit when you are finished using the xe CLI.

Accessing the xsconsole

1. See ““Accessing XenServer Shell” on page 2-3 and complete steps one

through three.

2. At the XE CLI prompt, type xsconsole. The menu-driven interface of the

xsconsole appears

Citrix-Xenserver login: root

Password:

Last login: Tue May 31 07:52:28 on hvc0

Type "xsconsole" for access to the management console.

<<<xsconsole pointer>>>

[root@Citrix-Xenserver ~]#