HP Advanced Services zl Module with Microsoft® Windows Server® 2008 R2 Installation and Getting Started Guide

1-4
Hardware Installation
Update the Switch Software
Figure 1-2. Module Operating System and Application
Update the Switch Software
If you need to install the HP zl switch that will house your module, refer to the
Installation and Getting Started Guide shipped with the switch or at
www.hp.com/networking/support.
Before installing the module, you must update the HP zl switch software to
version K.14.65 or later. K.15.03 software or later is recommended. (Visit the
HP Web portal at www.hp.com/networking to check the version number of the
latest compatible software.) You must install the correct software version for
the switch to recognize the module.
Follow these steps to install the new software:
1. Obtain the software and copy it to a USB drive.
2. You can copy the software from the USB drive directly to the switch, or
you can copy the file to a TFTP server and upload it from there.
• USB drive—Follow these steps:
i. Insert the USB drive in the HP zl switch USB slot.
Note This USB slot is at the top of the switch chassis. Do not use the one on the
module itself.
Hard DISK (HD)
Integrated AppSW
Compact Flash (CF)
Service OS