HP Advanced Services zl Module with Microsoft® Windows Server® 2008 R2 Installation and Getting Started Guide

1-5
Hardware Installation
Update the Switch Software
ii. Enter this command from the HP zl switch CLI:
hostzlswitch# copy usb flash <filename> secondary
iii. When prompted, press
[y].
• TFTP server—Follow these steps:
i. Copy the file to a TFTP server that has network connectivity to
the HP zl switch.
ii. Enter this command from the HP zl switch CLI:
hostzlswitch# copy tftp flash <TFTP server IP address>
<filename> secondary
iii. When prompted, press
[y].
Note If you need to stop this command or another, press either [Ctrl-C] or [Ctrl-Z]. Both
stop the command, but
[Ctrl-Z], unlike [Ctrl-C], does not provide any message
indicating that the command was stopped.
3. After the file has finished copying, you should see the prompt again as
shown in Figure 1-3.
Figure 1-3. HP zl Switch CLI—Software Copied
4. Set the startup-config file for the secondary software:
hostzlswitch# startup-default secondary config <filename>
For example:
hostzlswitch# startup-default secondary config config1