HP Advanced Services zl Module with Microsoft® Windows Server® 2008 R2 Installation and Getting Started Guide

2-4
Getting Started
Introduction
This guide will refer to the interfaces as interface 1, interface 2, and the
management interface.
Table 2-1. Module Interfaces
Interface HP zl Switch Side Module/Server Side Special Notes
HP zl switch CLI ID Module CLI (hp-svcs-
std) ID
Windows Server ID
Internal interface 1 <slot>1 1 Depends; find the 10G
Local Area
Connection with the
lower MAC address
• Disabled by default
• Can carry LAN
traffic
• Default IP settings
= DHCP enabled
Internal interface 2 <slot>2 2 Depends; find the 10G
Local Area
Connection with the
higher MAC address
• Enabled by default
• Can carry LAN
traffic
• Must never be
disabled (almost
always brought up
automatically by
the SMA)
• Default IP settings
= DHCP enabled
Management
interface
— management Depends; find the
Gigabit Local Area
Connection with a
higher MAC address
that the 10G
interfaces
• Enabled by default
•Provides
management
access to a
directly connected
device
• Default IP address
= 192.168.2.10/30
To connect to the
default address,
assign a
workstation IP
address
192.168.2.9.