HP Advanced Services zl Module with Microsoft® Windows Server® 2008 R2 Installation and Getting Started Guide

4-6
Special Guidelines for Using the Advanced Services zl Module with Microsoft Windows Server 2008 R2
Restoring the Module to the Factory Image
4. Wait a few moments. The module will then shutdown. The next steps
depend on how you accessed the command prompt:
• From the SAC—You will be returned to the SAC and warned that
the system is about to shut down. Wait. As the module reboots,
messages will be displayed.
• Via RDP—You will lose your RDP connection. Follow these steps:
i. Open a CLI management session with the HP zl switch in which
the module is installed.
ii. Move to the global configuration mode.
hostzlswitch# config
iii. Enter this command:
For example:
hostzlswitch(config)# services c tech
iv. If the module has not yet rebooted, the management session will
hang. Wait. As the module reboots, messages will be displayed.
Figure 4-3. Module Recovery Menu
5. When the Recovery Menu in displayed, enter R to restore the factory
default settings.
6. Press
[y] to confirm that you want to reimage the module, returning it to
its factory state.
Syntax: services <slot ID> tech
Replace <slot ID> with the ID for the slot in which the module
is installed.