HP Advanced Services zl Module with Microsoft® Windows Server® 2008 R2 Installation and Getting Started Guide

5-9
Troubleshooting
Gain Access to a Module that Has No Network Connectivity
ipconfig/all
b. Enter this command to enable the interface:
netsh interface set interface <interface name> ENABLED
You should then be able to regain access to the module.
Module’s Behavior Based on Enabled and Disabled
Interfaces
Table 5-1 indicates how the module behaves based on the status of its inter-
faces. when its interfaces are enabled or disabled, including virtual interfaces
when the server is implementing Microsoft Hyper-V.
Table 5-1. Effect of Enabling and Disabling Module Interfaces
Situation Interface 1 Interface 2 Result
(see
legend
at the
end of
table)
Supported?
No
Hyper-V
Hyper-V enabled on
Interface 1
No
Hyper-V
Hyper-V enabled on
Interface 2
Physical
Interface 1
(associated
with NIC)
Virtual
Interface 1
(associated
with IP
address)
Physical
Interface 2
(associated
with NIC)
Virtual
Interface 2
(associated
with IP
address)
1 Enabled Enabled A, B Yes
2 Enabled Disabled A, E Yes, but quickly
and
automatically
reverts to 1
3 Disabled Enabled C, B Yes (default)
4 Disabled Disabled C, E Yes, but quickly
and
automatically
reverts to 3
5 Enabled Enabled Enabled
A, B Yes
6 Enabled Disabled Enabled
C, B Yes, but the
Hyper-V
interface might
be unavailable
externally.
7 Disabled Enabled Enabled
C, B
8 Disabled Disabled Enabled
C, B
9 Enabled Enabled Disabled
A, E Yes, but quickly
and
automatically
reverts to 5