HP Advanced Services zl Module with Microsoft® Windows Server® 2008 R2 Planning and Design Guide

2-8
Solution 1: WAN Optimization and Survivability
Solution Implementation
tagged f2
untagged a15-a21
exit
vlan 8
name “LAN8”
ip address 10.10.8.1 255.255.255.0
tagged f2
untagged a22-a24
exit
ip routing
ip route 0.0.0.0/0 10.10.2.2
class zone LAN
port-list a2-a24,c2
class zone NORMAL
port-list f2
class zone WAN
port-list a1
policy zone intercept
class zone LAN WAN action intercept unidirectional
class zone WAN LAN action intercept unidirectional
class zone LAN NORMAL action intercept unidirectional
class zone WAN NORMAL action intercept unidirectional
class zone NORMAL WAN action intercept unidirectional
timesync sntp
sntp unicast
sntp server priority 1 10.1.2.10
time timezone -480
time daylight-time-rule continental-us-and-canada
HP Advanced Services zl Module with Microsoft
Windows Server 2008 R2
You should follow these steps to configure the module:
1. Install the module in the HP E5406 zl switch. Refer to the module’s
Installation and Getting Started Guide for detailed instructions.
2. Access the switch CLI and assign the module’s internal interface 2 to the
correct VLAN for the branch server. (This interface is enabled by default
and is typically used for LAN traffic as well as switch-to-module commu-
nications.)
hostzlswitch(config)# vlan <ID> untagged <slot>2