HP Advanced Services zl Module with Microsoft® Windows Server® 2008 R2 Planning and Design Guide

3-10
Solution 2: Survivable Wireless Networking
Solution Implementation
2. Access the switch CLI and assign the module’s internal interface 2 to the
correct VLAN for the branch server. (This interface is enabled by default
and is typically used for LAN traffic as well as switch-to-module commu-
nications.)
hostzlswitch(config)# vlan <ID> untagged <slot>2
In this example, the module is installed in slot E, and the server belongs
in VLAN 294:
hostzlswitch(config)# vlan 294 untagged e2
3. Move to the module’s CLI and set the module’s IP address.
a. View the Services zl Modules installed in the switch:
hostzlswitch(config)# show services
You should see output similar to the following. Note the slot letter and
index number for the service described as Branch Core Svcs Mod-
ule-Standard. For example, in Figure 3-3 you can see that the index
number is 2.
Figure 3-3. HP zl Switch CLI—show services Output
b. Access the module’s application OS:
For example, enter:
hostzlswitch# services c 2
Syntax: services <slot ID> <index number>
Replace <slot ID> with the ID of the slot in which the module
is installed.
Replace <index number> with the index number that you just
noted for the service.