HP Advanced Services zl Module with Microsoft® Windows Server® 2008 R2 Quick Start Guide

2-2

Getting Started

If you want to change the IP address, enter these commands:

hostzlswitch(hp-svcs-std-C)# windows SBMAdmin

You will be prompted for a password. Enter P@ssw0rd. You will then

be prompted to change the password. After you do, enter:

hostzlswitch(hp-svcs-std-C:win)# interface 2

hostzlswitch(hp-svcs-std-C:eth-2)# ip address <IP

address> <subnet mask>

hostzlswitch(hp-svcs-std-C:eth-2)# ip default-gateway

If you want, you can also specify the DNS server addresses:

hostzlswitch(hp-svcs-std-C:eth-2)# ip dns server-address

priority [1 | 2] <IP address>

Caution The module has two internal ports. The instructions above apply to port 2. You

must never disable this interface (<slot>2) from the HP zl switch CLI. Other-

wise, the module will fault. It is also recommended that you do not disable

interface 2 from the module CLI nor the Local Area Connection associated

with this interface on the Windows Server 2008 R2 that is running on the

module. See the Installation and Getting Started Guide for more details.