HP ProCurve 700wl Series - Secure Access Configuration Guide for Wireless Clients (April 2005) Part One: Browser-Based Logons

Figure 1.4 – New Rights Assignment

f. Browse to Status -> Client Status and click Refresh User Rights Now.

2) Configure Static WEP parameters on the AP 420.

a. From the AP 420 CLI, configure the Static WEP security suite, WEP key

and key length.

HP ProCurve Access Point 420# configure

HP ProCurve Access Point 420(config)# int wireless g

Enter Wireless configuration commands, one per line.

HP ProCurve Access Point 420(if-wireless g)# security-suite 2

HP ProCurve Access Point 420(if-wireless g)# wep-key 1 ascII

1111111111333

HP ProCurve Access Point 420(if-wireless g)# key-length-wep 128

3) Connect Windows XP Client, logon using browser-based logon and verify

authentication.

a. Connect the wireless Windows XP client to the AP 420 using the Static

WEP key.

b. Open a Web browser on the client. The 700wl logon page will appear.

(You may need to configure the browser to accept all cookies).

c. Enter the username (juser) and password (password) and click the

Logon User button.