HP ProCurve 700wl Series - Secure Access Configuration Guide for Wireless Clients (April 2005) Part One: Browser-Based Logons

Step 2: Configuring the Access Control Server 740wl

This example uses an Access Control Server 740wl. The configuration steps are the same if

you are using an Integrated Access Manager 760wl.

Power up the ACS, connect a serial console cable and configure the following at the ACS CLI:

1. Configure an IP address, subnet mask and default gateway.

2. Configure the shared secret (secret).

HP 700wl Series@[42.0.0.1]: set ip 10.24.3.50 255.255.255.0

HP 700wl Series@[10.24.3.50]: set gateway 10.24.3.1

HP 700wl Series@[10.24.3.50]: set sharedsecret secret secret

Step 3: Configuring the Access Control xl Module

To configure the ACM, go to the Switch 5300xl CLI and configure the following:

1. Enter the Access Controller configuration context.

2. Set the IP address, subnet mask and default gateway of the ACM.

3. Set the IP address of the Access Control Server 740wl that will be used to manage

the ACM.

4. Set the shared secret (secret) to match the configuration on the ACS.

5300xl> en

5300xl# config term

5300xl(config)# access-controller d

5300xl(access-controller-D)# enable extended-commands

5300xl(access-controller-D-ext)# set ip 10.24.3.66/24

5300xl(access-controller-D-ext)# set gateway 10.24.3.1

5300xl(access-controller-D-ext)# set accesscontrolserver 10.24.3.50

5300xl(access-controller-D-ext)# set sharedsecret secret secret

Use the “show status” command to verify that the ACM is connected to the ACS.

5300xl(access-controller-D-ext)# show status

Uptime: 1 hr, 7 mins.

Access Controller Function

Access Control Server: 10.24.3.50

Connected: 10 mins, 27 secs

Active Clients: 0

Total Sessions: 0

Step 4: Configuring the Access Point 420

Initial configuration of the Access Point 420 for this guide requires two tasks be

completed.

Configuring the Access Point for general network and wireless

Connect a serial console cable to the AP 420 and configure the following at the AP

420 CLI:

• IP address, subnet mask and gateway.