HP ProCurve Switch /Wireless - Interoperability between ProCurve WESM zl and Polycom-SpectraLink phones

Interoperability between ProCurve WESM zl and Polycom-SpectraLink phones

HP ProCurve Networking

5.1.3 Configure SVP-II Mode to be the NetLink IP:

1. With the highlight on SVP-II TFTP Download Master, press Enter to select it. The screen is immediately

redrawn with additional options for the IP environment.

2. Configure the following parameters as required:

o Phones per Access Point: 12 (leave default)

o First and Last alias IP address: Range of IP addresses used by the wireless phones to register the

H.323 gatekeeper

o Enable H.323 Gatekeeper: Y

5.2 Configure the wireless phones

In this example, you configure two wireless telephones. To configure a SpectraLink wireless telephone:

1. Press both the green and red buttons, then release the green one.

2. Then use the arrows on the left side of the phone for configuration.

5.2.1 Configure the phone:

• Phone configuration: Leave everything set to default

5.2.2 Configure the network:

For network configuration:

• IP addresses: You have the choice between Static and DHCP configuration:

o Static IP: Configure the following parameters:

 Phone IP: 10.1.40.150 or 10.1.40.151 in this example

 TFTP server IP: 10.1.10.100 in this example

 Default Gateway: 10.1.10.1

 Subnet Mask: 255.255.255.0

 SVP IP address: 10.1.40.11

 RTC IP address: 10.1.40.10 (Mitel IPBX)