HP ProCurve Switch / Wireless - Using 802.11e and WMM on the ProCurve Wireless Edge Services Module

Using 802.11e and WMM on the ProCurve Wireless Edge Services Module
HP ProCurve Networking
6
2. To modify the WMM parameter for an access category, highlight the category and click Edit at the bottom left
of the screen. You see the Edit WMM window:
3. From the same window you can also configure the QoS parameters: AIFSN, Transmit Ops, CW Minimum, CW
Maximum
3.4 Configure admission control
Finally, you can configure admission control, to limit the number of wireless stations that can use the same QoS
settings at the same time. (This is for Voice and Video categories only.)
To configure Admission Control:
1. Select Network Setup > WLAN Setup and click the WMM tab.
2. Select the queue for which you want to alter the settings, and then click the Edit button. The Edit WMM screen
is displayed:
3. Enable the Admission Control check box, and enter the number of stations. Then click OK to accept the new
settings.