HP ProCurve Switches / Wireless - Interoperability between the Aastra Wireless Phone 312 and ProCurve Wireless Services

Interoperability between the Aastra Wireless Phone 312 and ProCurve Wireless Services

HP ProCurve Networking

1. Introduction

This document describes how the interoperability of the ProCurve wireless services solution and an Aastra wireless

phone 312 can be used to provide a secure VoWLAN solution with the following services:

• Secure wireless encryption with WPA/WPA2

• Fast roaming

• Quality of Service on the wireless media, with WMM

• Unscheduled Automated Power Save Delivery (uAPSD)

2. Prerequisites

You have a ProCurve Switch 5406zl or 8212zl with a Wireless Services Edge Module zl and radio ports installed. The

radio ports have been discovered.

For more information on this configuration please refer to application note AN-M1, Extend your wired network to

wireless.

3. Network diagram

Figure 1 details the configuration referenced in this section.

Figure 1. System configuration

Equipment needed:

• A ProCurve Switch 5406zl with latest firmware version.

• A Wireless Edge Services Module zl (WESM zl) plugged into a slot of the 5406zl.

• 2 radio ports (RP210 or RP230)

• A management server configured as a domain controller, with a RADIUS server installed (IAS in this

application note) and ProCurve Manager Plus (optional).

• An Aastra 312 wireless SIP phone.

4. Secured wireless encryption

The Aastra wireless SIP phone 312 supports the following security options:

• WEP

• WPA1-PSK

• WPA2-PSK

This section describes how to configure WPA2-PSK authentication.