Manualshelf

HP ProCurve Switches / Wireless - Interoperability between the Aastra Wireless Phone 312 and ProCurve Wireless Services

ManualsBrandsHP ManualsComputer AccessoriesHP ProCurve Switch xl Access Controller Module
12345678910
Interoperability between the Aastra Wireless Phone 312 and ProCurve Wireless Services
HP ProCurve Networking
8
5.3 Test the roaming time
You can determine the roaming time by first using the WESM to determine the radio port to which the phone is
associated. To test roaming time:
1. From Device Association > Wireless Stations, note the radio’s Station Index.
2. Go to Device Association > Radio Adoption Statistics and determine the MAC address of the corresponding
radio port.
3. To determine the switch port associated with this MAC address, use ProCurve Manager’s find node tool.
o Use the command show lldp info remote all on the switch if the radio ports are connected at layer 2.
o Or use show arp if the radio ports have IP addresses.
4. From the Aastra phone Ping tool, launch a ping to the IP address of the Aastra Call Controller, or else to the
network default gateway if no call controller is present. The ping launched from the Aastra phone Ping tool is a
continuous ping.
5. From the switch CLI or Web agent disable the port of the RP to which the phone is associated. The phone
should lose one or two pings, then subsequent pings should be successful again.
If you have an Aastra Call Controller (Aastra 5000 or Aastra 800, for example) up and running on the network,
you can initiate a phone call to another phone on the network and then disable the radio port. The
communication link should remain on, and the voice should be lost for less than one second.
6. Configuring 802.11e and uAPSD
This section details how to configure WMM (802.11e) and the Unscheduled Automatic Power Save Delivery (uAPSD)
features.
6.1 Configure WMM on the WESM
To configure WMM on the Wireless Edge Services Module:
1. Edit the voice WLAN.
2. In Advanced Parameters, set the Access Category to Automatic WMM.
3. In Network Setup > WLAN Setup > Edit screen, go to the WMM tab and verify that the voice VLAN is
configured for WMM with four queues: Voice, Video, Background and Best Effort.
4. If desired, you can modify the parameters of these different classes of traffic:
o AIFSN
o Transmit Ops
o CW Minimum
o CW Maximum
o Use DSCP or 802.1p priority (DSCP by default)