HP ProCurve Threat Management Solution Implementation Guide 2009-05

3-46
HP ProCurve Network Immunity Manager with a Third-Party IDS/IPS
Step 2: Detect Threats
Figure 3-45. Sample Network Illustrating an Inline IPS
This section describes the additional setup required if you are using the Cisco 4200 Series
Sensor as an IPS. Configuring NIM’s response to the threat is covered in “Step 3: Respond to
Threats” on page 3-126.
To set up the Cisco Series Sensor as an IPS, complete the following steps:
1. Check the current sensor configuration.
a. Click Configuration in the toolbar.
b. At the bottom of the navigation bar, click the Interfaces tab to expand the interface
configuration options.