HP ProCurve Threat Management Solution Implementation Guide 2009-05

4-36
HP ProCurve Network Immunity Manager with HP ProCurve Security Devices
Step 2: Detect Threats
Subtask: Configure SNMP Settings
To enable PCM+ to discover the TMS zl Module, you must configure the module to use the
same SNMP settings that you are using on PCM+. If PCM+ is configured to SNMP v2, for
example, you must configure the TMS zl Module to use SNMP v1/v2, and you must configure
the module’s SNMP communities to match the communities configured on PCM+.
To configure SNMP settings on the TMS zl Module, complete the following steps:
1. Click System > Settings and click the SNMP tab.
Figure 4-26. System > Settings > SNMP Window
Continue with one of the following:
■ “Subtask: Configure SNMPv1/v2c Settings” on page 4-36
■ “Subtask: Configure SNMPv3 Settings” on page 4-37
Subtask: Configure SNMPv1/v2c Settings. To configure SNMPv1/v2c settings, complete
the following steps:
1. In the System > Settings > SNMP window, select Enable SNMPv1/v2.
2. Under Enable SNMPv1/v2, click Add another community. The Add SNMPv1/v2 Community
window is displayed.
Figure 4-27. Add SNMPv1/v2 Community Window
3. For Community Name, type the community name for the PCM+/NIM server.