HP ProCurve Threat Management Solution Implementation Guide 2009-05

4-64
HP ProCurve Network Immunity Manager with HP ProCurve Security Devices
Step 2: Detect Threats
To configure SNMP traps, complete the following steps:
1. Click System > Logging and then click the SNMP Traps tab.
Figure 4-10. System > Logging > SNMP Traps Window
2. To enable SNMP traps, do one or both of the following:
• Select the Enable SNMPv2 traps check box.
• Select the Enable SNMPv3 traps check box.
3. If you enabled SNMPv2 traps, configure the server address and community name:
a. Click Add another destination. The Add SNMPv2 Destination window is displayed.
Figure 4-11. Add SNMPv2 Destination Window
b. For Server Address, type the IP address or Fully Qualified Domain Name (FQDN)
of PCM+.
c. For Community Name, type the read-write (unrestricted) community name.You must
enter the read-write community name that is configured on PCM+.
d. Click OK.
4. Click Save.