HP ProCurve Threat Management Solution Implementation Guide 2009-05

A-9
Initial Setup for HP ProCurve Manager Plus and Network Immunity Manager
Install PCM+
23. Click Next. The Initial Discovery Settings page is displayed.
24. In the Start from device box, type the IP address of a switch in the Management VLAN (in
this example, the address of the routing switch: 10.2.0.1).
Figure A-15. ProCurve Manager Install Wizard—Initial Discovery Settings Page
25. The Automatically register as a trap receiver check box should be selected by default.
26. Click Next. The Set default SNMP parameters page is displayed.
27. In this example, the network uses SNMPv2. Accept the default primary and secondary
SNMP versions under Discovery Version.
28. Under V2 Credentials:
a. For the Read Community, type procurvero.
b. For the Write Community, type procurverw.