HP ProCurve Threat Management Solution Implementation Guide 2009-05

A-10
Initial Setup for HP ProCurve Manager Plus and Network Immunity Manager
Install PCM+
Figure A-16. ProCurve Manager Install Wizard—Set default SNMP parameters Page
29. Click Next. The Set default CLI parameters page is displayed
30. Configure command-line interface (CLI) access from PCM+ to ProCurve devices. The
default configuration uses Telnet.
a. Select Telnet or SSH (secure).
b. In the Timeout in sec box, type a number between 1 and 60.
c. In the Retries box, type a number between 1 and 5.
d. If you have selected SSH, configure some settings:
i. For SSH Version, select SSH1 or SSH2.
ii. For SSH Auth, select Password or Key.
e. For Mgr Username, type the management username for devices in your network (in this
example, adminswitch).
f. For Mgr Password, type the associated password.
g. For Opr Username, type the username for operators in your network (in this example,
operatorswitch).
h. For Opr Password, type the associated password.