HP Survivable Branch Communication zl Module powered by Microsoft Lync Planning and Design Guide 2011-02

4-27
Example Solutions
Solution
Figure 4-23. Lync Server 2010 Topology Builder > Define New Survivable
Branch Server—Select an Edge Server Page
13. If your site provides remote access, select the Edge pool at the central site
that the branch site will use, and click Next.
If your central office does not provide remote access, you will not have
defined an Edge pool. In this case, simply click Next.
14. For Gateway FQDN or IP address, type the same SBM FQDN that you
specified for the survivable branch appliance, seattle-sbm.example.hp.com.
Note You must specify the SBM’s FQDN, not its IP address.
15. Select TLS for the SIP Transport Protocol.
16. The Listening port for PSTN gateways field fills in automatically based on
the selected protocol. For this example, you will use the default port. The
default port in this wizard matches the default port in the SBM Setup
Wizard: port 5068 for SIP over TCP and port 5067 for SIP over TLS.