HP Survivable Branch Communication zl Module powered by Microsoft Lync Planning and Design Guide 2011-02

4-71
Example Solutions
Solution
Figure 4-61. Setup Wizard—Configure IP Settings Page
13. Leave the current interface enabled (this is the interface mapped to the
SBM’s internal port 2, and disabling it causes the module to fault).
Click Next.
14. The SBM takes its clock from the HP zl switch in which it is installed.
However, you must set its timezone and Daylight Saving Time policy.
These settings must match those settings on the HP zl switch, or the
installation will fail.
Important The installation will fail if the switch’s clock is not synchronized with the
domain controller’s. You should have verified the switch’s clock setting when
you installed the SBM. See HP Survivable Branch Communication zl Module
powered by Microsoft Lync
TM
Installation and Getting Started Guide.