HP Survivable Branch Communication zl Module powered by Microsoft Lync Planning and Design Guide 2011-02

4-82
Example Solutions
Solution
Note When you select a second check box in the Select Boards section, you no longer
see the interfaces for the first board in the Select Interfaces for Board section.
However, the interfaces on the first board are still selected.
11. If you have FXS interfaces, you must fill in the Caller Name and Phone
Number for each. (Refer to your PSTN carrier for the correct phone
numbers.) Enter the full phone number, but not the E.164 number.
In this example, use these settings:
•FXS 1
– Caller Name = Fax1
– Phone Number = 14255551111
•FXS 2
– Caller Name = Fax2
– Phone Number = 14255552222
Figure 4-72. Setup Wizard—Hardware Configuration Page
12. Click Next.
13. Select your country, which automatically configures the SBM to use the
correct tones to detect dial tone, busy signal, and so forth. For this
example, select USA.