HP Survivable Branch Communication zl Module powered by Microsoft Lync Planning and Design Guide 2011-02

4-91
Example Solutions
Solution
40. To apply your changes, you must restart the gateway. Click Stop under
Media Gateway Status in the PSTN Configuration page. After the status
indicates that the gateways has stopped, click Start.
41. Click Next in the PSTN Configuration page.
In the next page, you initiate a PSTN call to test the connection. However, you
chose to require encryption for SIP, which causes the call to fail. You have two
choices:
■ Run the PSTN Setup Wizard and choose to support but not require
encryption. Then complete the test call. After the call is successful, you
can run the wizard again and choose to require encryption.
■ Skip the PSTN test call and only perform the Lync test call, which tests
both the PSTN connection and the Lync routing rules.
For this solution, you will select the second option.
42. Click Next in the Verify PSTN Configuration Page.
43. You will now start the Lync Server services. Click Start Lync Services.
Figure 4-85. Setup Wizard—Start Lync Services Page
This step might take a minute or so. Figure 4-86 displays the page after
the process has completed successfully.