HP Survivable Branch Communication zl Module powered by Microsoft Lync Planning and Design Guide 2011-02

2-49

Design Considerations

Planning Ease of Management

This section describes the options that you and others have for managing the

SBM.

Initial Installation

Table 2-24 displays the tasks that must be performed to bring the SBM from

the factory box to up and running. The entire process can be completed within

one hour to an hour and a half depending on your environment. You can divide

various tasks among different personnel, or you can have the same person

perform the tasks.

Important Before the initial installation, Domain or Enterprise Admins and CS Adminis-

trators must prepare the data center for the deployment. Chapter 3: “Ready

the Data Center for an SBM Deployment” provides guidelines.

Table 2-24. Installation Process

Estimated Time Task Reference

25 minutes Install the HP E5400 zl or E8200 zl

Series switch (if not already

installed)

Installation and Getting Started Guide for your switch

8 minutes Update the HP zl switch software HP Survivable Branch Communication zl Module (SBM)

Installation and Getting

Started Guide

2 minutes Set the HP zl switch time HP Survivable Branch Communication zl Module (SBM)

Installation and Getting

Started Guide

5 minutes Install PCIe cards in the SBM PCIe Analog Card (FXO or FXS) and Digital Card Installation

Instructions shipped with these cards

5 minutes Install the SBM in the HP zl switch HP Survivable Branch Communication zl Module (SBM)

Installation and Getting

Started Guide

15 minutes Wait for the initial bootup HP Survivable Branch Communication zl Module (SBM)

Installation and Getting

Started Guide

10 minutes Complete initial setup in the HP zl

switch and SBM command-line

interface (CLI)

HP Survivable Branch Communication zl Module (SBM)

Installation and Getting

Started Guide