HP TMS zl Module Security Administrator's Guide

1-5
Managing TMS zl Modules
Introduction
TMS zl Module Web Browser Interface Comparison
There are some features that can be configured on the TMS zl Modules via the
TMS zl Module Web browser interface but cannot be configured via NIM.
These include:
■ DNS
■ DHCP relay
■ Firewall, Application Level Gateways (ALGs)
■ Routing
For information on configuring these features on the TMS zl Modules, please
see the HP Threat Management Services zl Module Management and Con-
figuration Guide available at: www.hp.com/networking/manuals.
■ For DNS and DHCP Relay, see Chapter 2, “Initial Setup in Routing
Mode”.
■ For Firewall, ALGs, see Chapter 4, “Firewall”.
■ For Routing, see Chapter 9, “Routing”.
TMS zl Module Manual Configuration
Some manual configuration must be completed on the TMS zl Module before
NIM can communicate with the module or be used to manage the module’s
configuration, as shown in the following steps. Instructions for initial manual
configuration of the TMS zl Module using the CLI are provided in the HP
Threat Management Services zl Module Management and Configuration
Guide available at: www.hp.com/networking/manuals. See Chapter 2 in that
manual, for the management access configuration, and Chapter 8, for details
about HA configuration.
The following features must be manually configured:
1. Create VLAN interfaces on the switch or switches in which the TMS zl
Modules are installed: a Management VLAN and an HA VLAN. If the
modules are installed in different switches, make sure that the configura-
tion for these VLANs is the same on both switches.
2. Associate the Management VLAN with a zone. (HP recommends that you
do not associate the HA VLAN with a zone.)