HP TMS zl Module Security Administrator's Guide

3-19
Configuring a TMS zl Module as an IPS
Configuring IPS
If the status column is updated for some signatures (signatures are selected
and enable/disable is applied), these settings will remain even if any filter is
applied/removed/changed.
Figure 3-8. IPS Signatures Wizard, Select Signatures
3. Select the signatures to be enabled or disabled as follows and click Enable
IPS Signatures or Disable IPS Signatures after each selection:
If you selected a single TMS module, this step shows the status of the
signatures configured on the module. In case of multiple devices, the
status column is left blank. You can apply the status of required signatures.
Only those signatures’ status will be updated in the selected TMS modules
for which you have applied the status. Remaining fields show the status
in all TMS modules.
Moving the cursor over a signature displays a brief description of the
signature.
• To enable/disable a specific signature, select the signature.
• To enable/disable multiple contiguous signatures, select the signa-
tures with the mouse while holding down the left-click button.