HP TMS zl Module Security Administrator's Guide

4-35
Configuring a VPN on the HP TMS zl Module
Configure an IPsec Client-to-Site VPN
Figure 4-16. Deploy IPsec Remote-Access VPN Wizard > Configure Public Interface
and Local ID
8. For Local Gateway, specify the TMS zl Module IP address that will act as
the VPN gateway. You have two options:
•Select IP Address and type an IP address in the box.
The IP address must be an IP address that is already configured on
the TMS zl Module and that the remote endpoints can reach. For
example, if the remote endpoints connect to the module through the
Internet, specify the IP address on the module’s Internet VLAN.
•Select Use VLAN and select a VLAN from the list (which includes all
TMS VLANs on this module).
Select the VLAN on which the remote endpoints reach the TMS zl
Module. For example, if the remote endpoints connect to the module
through the Internet, specify the VLAN that connects to the Internet.
9. For Local ID, configure the ID that the TMS zl Module sends to authenticate
itself. This ID must match exactly, in both type and value, the remote ID
that is configured on remote endpoints. For more information about ID
types, see “Exchange 3: Authentication” on page 4-16.