HP TMS zl Module Security Administrator's Guide

4-48
Configuring a VPN on the HP TMS zl Module
Configure an IPsec Client-to-Site VPN
Figure 4-23. Deploy IPsec Remote-Access Wizard > Configuration Preview
20. Review the configuration settings you have selected. If you want to save
the changes as well as apply them, select the Save Configuration check box.
If the TMS zl Module is a master in a cluster and you want to immediately
synchronize the changes, select the Synchronize changes to Participant
check box. Note that this will cause the participant to reboot.
If you need to change any settings, click Back until you reach the appro-
priate window and can select a different setting.
When you are ready to apply the configuration, click Next in the Configu-
ration Preview window.
21. A window is displayed, showing the settings being applied to the TMS zl
Module. When you see that they have been applied successfully, click
Close.
Move to “Create Access Policies for IPsec Client-to-Site VPNs” on page 4-102.
Custom Setup
To use the Custom setup to configure a client-to-site VPN, complete the
following steps: