HP TMS zl Module Security Administrator's Guide

4-62
Configuring a VPN on the HP TMS zl Module
Configure an IPsec Client-to-Site VPN
Figure 4-33. Deploy IPsec Remote-Access VPN Wizard > Configure Services
Available for the Remote End Point
20. For Protocol, specify the protocol for traffic allowed over the VPN:
• Any—Any IP protocol. Select this option when you want to select all
traffic between local and remote endpoints.
• TCP or UDP—Select this option in conjunction with a local port to
allow remote clients to access only specific services in the local
network.
• IP Protocols—Select one of these Layer 3 protocols, which are listed
by their IANA IP Protocol names.
Service objects and service groups will not appear in this list.
21. The Local Network Address and Remote Peer Address are displayed but
grayed out; you configured these settings earlier in the wizard.
22. If you selected TCP or UDP, you can specify the Local Port and Remote Port.
The local port determines the services available to remote endpoints. If
you want to allow all TCP or UDP traffic, leave the fields empty.
23. Click Next.