HP TMS zl Module Security Administrator's Guide

4-164
Configuring a VPN on the HP TMS zl Module
Configuring an IPsec Site-to-Site VPN with IKE
Figure 4-105. Deploy IPsec Site-to-Site VPN > Configure Identifiers
9. Under Hub to Spoke 1, first configure the ID that the hub TMS zl Module
sends to authenticate itself to the Spoke 1 module. (For more information
about ID types, see “IKE Phase 1” on page 4-14.)
a. For Local ID type, select the ID type for the hub module:
– IP Address
– Domain Name
– Email Address
– Distinguished Name
b. For Local ID Value, type the correct value for the hub module’s ID.
If you select IP Address for the type, the value must be the IP address
that you earlier specified for the hub gateway (or the IP address on
the specified VPN).
Table 4-18 shows the format for each ID type.