HP TMS zl Module Security Administrator's Guide

4-165
Configuring a VPN on the HP TMS zl Module
Configuring an IPsec Site-to-Site VPN with IKE
Table 4-18. Local ID Values
10. Under Hub to Spoke 1, next specify the ID that the Spoke 1 TMS zl Module
sends to authenticate itself to the hub module.
a. For Remote ID Type, select the ID type for the Spoke 1 module:
– IP Address
– Domain Name
– Email Address
– Distinguished Name
b. For Remote ID Value, type the correct value for the Spoke 1 module’s
ID.
Again, if you select IP Address, leave the value that is automatically
populated.
Note The wizard will automatically generate settings for the Spoke 1 identifiers by
reversing the local and remote IDs.
11. If you are configuring a second spoke, under Hub to Spoke 2, repeat steps
9 and 10. For Local ID Type and Local ID Value, specify the ID that the hub
module sends to authenticate itself to the spoke 2 module. For Remote ID
Type and Remote ID Value, specify the ID that the spoke 2 module sends to
authenticate itself to the hub module.
Local ID Type Remote ID Value Examples
IP Address A.B.C.D 172.16.40.103
Domain Name <domainname> TMS.hp.com
Email Address <name>@<domainname> [e-mail]
Distinguished
Name
/CN=<commonname> /CN=TMS.hp.com