HP TMS zl Module Security Administrator's Guide

4-418
Configuring a VPN on the HP TMS zl Module
Manage Certificates
Figure 4-319. Manage Certificates Wizard > Configuration Preview
7. Review the configuration settings you have selected. If you want to save
the changes as well as apply them, select the Save Configuration check box.
If the TMS zl Module is a master in a cluster and you want to immediately
synchronize the changes, select the Synchronize changes to Participant
check box.Note that this will cause the participant to reboot.
If you need to change any settings, click Back until you reach the appro-
priate window and can select a different setting.
When you are ready to apply the configuration, click Next in the Configu-
ration Preview window.
8. The CRL is downloaded and installed on the TMS zl Module. After the
process completes successfully, close the window.
You have finished installing certificates.
Install Certificates Using SCEP
Before you begin to configure the settings for using SCEP to install certifi-
cates, make sure the time and the time zone on the TMS zl Module match those
set on the SCEP server. If the module does not have the same time and time
zone as the SCEP server, the SCEP process may fail. The TMS zl Module takes
its time from the host switch, so if you need to adjust the time, you will need
to configure the switch.