HP VPN Firewall Appliances Access Control Command Reference

123
Syntax
portal nas-ip ipv4-address
undo portal nas-ip
Default
No source IP address is specified for outgoing portal packets on an interface, and the interface uses the
IP address of the user access interface as the source IP address for outgoing portal packets.
Views
Interface view
Default command level
2: System level
Parameters
ipv4-address: Specifies a source IPv4 address for outgoing portal packets. This IP address must be a
local IP address, and cannot be 0.0.0.0, 255.255.255.255, a class D address, a class E address, or a
loopback address.
Examples
# Configure interface GigabitEthernet 0/1 to use 2.2.2.2 as the source IPv4 address for outgoing portal
packets.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] portal nas-ip 2.2.2.2
portal nas-port-id
Use portal nas-port-id to specify the NAS-Port-ID value carried in a RADIUS request.
Use undo portal nas-port-id to restore the default.
Syntax
portal nas-port-id nas-port-id-value
undo portal nas-port-id
Default
No NAS-Port-ID value is specified for an interface, and the device uses the information obtained from the
physical interface where the portal user accesses as the NAS-Port-ID value in a RADIUS request.
Views
Interface view
Default command level
2: System level
Parameters
nas-port-id-value: NAS-Port-ID value, a case-sensitive string of 1 to 253 characters. This value is used as
the value of the NAS-Port-ID attribute in the RADIUS request to be sent to the RADIUS server when a
portal user logs on from an interface.