HP VPN Firewall Appliances Access Control Configuration Guide

129
Figure 103 Enabling static NAT on an interface
4. Configure virtual fragment reassembly:
a. Select Firewall > Session Table > Advanced from the navigation tree.
b. Select Trust for Security Zone.
c. Select the Enable Virtual Fragment Reassembly box.
d. Click Apply.
Figure 104 Configuring virtual fragment reassembly
After the configuration, if the firewall receives disordered fragments from security zone Trust, it examines
and reassembles them.
Configuring virtual fragment reassembly at the CLI
Configuration procedure
To configure IP virtual fragment reassembly:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VD system view.
switchto vd vd-name
Required if you want to
create a security zone for a
non-default VD.