HP VPN Firewall Appliances Access Control Configuration Guide

242
Figure 146 Configuring the communication parameters
7. Enable telnet services on the firewall:
a. Select Device Management > Service Management from the navigation tree.
b. Select the box next to Enable Telnet service.
c. Click Apply.
Figure 147 Enabling the Telnet service
8. At the CLI, configure the firewall to use username and password authentication for telnet users and
configure the ISP domain to use the HWTACACS scheme system:
<Firewall> system-view
[Firewall] user-interface vty 0 4
[Firewall-ui-vty0-4] authentication-mode scheme
[Firewall-ui-vty0-4] quit
[Firewall] domain bbb
[Firewall-isp-bbb] authentication login hwtacacs-scheme system
[Firewall-isp-bbb] authorization login hwtacacs-scheme system
[Firewall-isp-bbb] accounting login hwtacacs-scheme system
[Firewall-isp-bbb] quit
Verifying the configuration
Telnet to the firewall by entering the username in the format of userid@bbb and the correct password,
and then you can enter the user interface of the firewall. Use the display connection command on the
firewall to view information about the user connection.