HP VPN Firewall Appliances Access Control Configuration Guide

18
Ste
p
Command Remarks
5. Create or edit a rule.
rule [ rule-id ] { deny | permit }
protocol [ { { ack ack-value | fin
fin-value | psh psh-value | rst
rst-value | syn syn-value | urg
urg-value } * | established } |
counting | destination { dest-address
dest-wildcard | any } |
destination-port operator port1
[ port2 ] | dscp dscp | fragment |
icmp-type { icmp-type [ icmp-code ] |
icmp-message } | logging |
precedence precedence | reflective
| source { source-address
source-wildcard | any } |
source-port operator port1 [ port2 ]
| time-range time-range-name | tos
tos | vpn-instance
vp
n-instance-name ] *
By defa
ult, an IPv4 advanced ACL does
not contain any rule.
The logging keyword takes effect only
when the module (for example, a
firewall) using the ACL supports logging.
6. Add or edit a rule
comment.
rule rule-id comment text
Optional.
By default, no rule comments are
configured.
7. Add or edit a rule
range remark.
rule [ rule-id ] remark text
Optional.
By default, no rule range remarks are
configured.
Configuring an IPv6 advanced ACL
IPv6 advanced ACLs match packets based on the source IPv6 addresses, destination IPv6 addresses,
packet priorities, protocols carried over IPv6, and other protocol header fields such as the TCP/UDP
source port number, TCP/UDP destination port number, ICMPv6 message type, and ICMPv6 message
code.
Compared to IPv6 basic ACLs, IPv6 advanced ACLs allow more flexible and accurate filtering.
To configure an IPv6 advanced ACL:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an IPv6
advanced ACL
and enter its view.
acl ipv6 number acl6-number [ name
acl6-name ] [ match-order { auto |
config } ]
By default, no ACL exists.
IPv6 advanced ACLs are numbered in the
range of 3000 to 3999.
You can use the acl ipv6 name acl6-name
command to enter the view of a named
ACL.
3. Configure a
description for the
IPv6 advanced
ACL.
description text
Optional.
By default, an IPv6 advanced ACL has no
ACL description.
4. Set the rule
numbering step.
step step-value
Optional.
The default setting is 5.