HP VPN Firewall Appliances Access Control Configuration Guide

2. Enter the IP address in the field, and choose whether you want to query by source or destination

IP address from the list.

3. Click Search.

The page displays the policies with the source or destination IP address.

Configuring an interzone policy group

Configuration prerequisites

Before configuring an interzone policy group, complete the following tasks:

• Create security zones to which you will apply an interzone policy (see "Configuring security

zones").

• Configure IPv4 basic or advanced ACLs (see "Configuring ACLs").

Configuration procedure

To configure an interzone policy group:

1. Select Firewall > Security Policy > Interzone Policy Group from the navigation tree to enter the

interzone policy group list page.

Figure 68 Interzone policy group list

Table 22 Operations you can perform on the list

Field O

eration

Referenced ACLs

Click an ACL to enter the ACL configuration page, where you can view, create, and

delete rules in the ACL. For information about ACL configuration, see "Configuring

ACLs."

Status

• shows that the interzone policy group is enabled. Click Disable to disable the

interzone policy group.

• shows that the interzone policy group is disabled. Click Enable to enable the

interzone policy group.

NOTE:

The "Match Counter" field refers to the number of times that the interzone policy rule has been

matched. Click Clear match counter to clear the match counters of all interzone policy rules and

interzone policy groups.

2. Then click Add to enter the interzone policy group configuration page.