HP VPN Firewall Appliances Attack Protection Configuration Guide

120
• Configure ACLs for special packets or users.
Configuring the URPF in the Web interface
Configuring URPF
1. From the navigation tree, select Intrusion Detection > URPF Check to enter the URPF check
configuration page, as shown in Figure 100.
Figure 100 URPF check configuration page
2. Configure URPF settings for the security zone, as shown in Table 24.
3. Click Apply.
Table 24 Configuration items
Item Descri
p
tion
Security Zone
Security zone where the URPF check is to be configured. URPF configuration takes
effect on all the interfaces in the security zone.
IMPORTANT:
URPF configuration takes effect on the packets received by the interfaces in the security
zone only.
Enable URPF
Enable/disable URPF check.
If this box is not selected, URPF check is disabled and the following parameters are
not configurable.
Allow Default Route Allow using the default route for URPF check.
ACL Reference an ACL.
Type of Check Set the URPF check type, Strict or Loose.
URPF configuration example
Either Device A or Device in the configuration example can be used as a firewall.