HP VPN Firewall Appliances Getting Started Command Reference

32
Use undo telnet client source to remove the configuration.
Syntax
telnet client source { interface interface-type interface-number | ip ip-address }
undo telnet client source
Default
No source IPv4 address or source interface is specified for outgoing Telnet packets. The source IPv4
address is the primary IPv4 address of the outbound interface.
Views
System view
Default command level
2: System level
Parameters
interface interface-type interface-number: Specifies a source interface. The primary IP address of this
interface will be used as the source IPv4 address for outgoing Telnet packets.
ip ip-address: Specifies a source IPv4 address.
Usage guidelines
The source IPv4 address or source interface specified by this command is applicable to all Telnet
connections. However, if a user specifies a source IPv4 address or source interface when executing the
telnet command, the setting specified by the user takes effect.
This command is not supported in FIPS mode.
Examples
# Set the source IPv4 address for outgoing Telnet packets to 1.1.1.1 when the device serves as a Telnet
client.
<Sysname> system-view
[Sysname] telnet client source ip 1.1.1.1
Related commands
display telnet client configuration
telnet ipv6
Use telnet ipv6 to Telnet to a host in an IPv6 network
Syntax
telnet ipv6 remote-host [ -i interface-type interface-number ] [ port-number ] [ vpn-instance
vpn-instance-name ]
Views
User view
Default command level
0: Visit level