HP VPN Firewall Appliances Getting Started Command Reference

Parameters

command: Specifies the command to be automatically executed.

Usage guidelines

This command is not supported on the console user interface.

The system automatically executes the specified command when a user logs in to the user interface, and

tears down the user connection after the command is executed. If the command triggers another task, the

system does not tear down the user connection until the task is completed.

The command auto-execute function is typically used for redirecting a Telnet user to a specific host.

Examples

# Configure the device to automatically Telnet to 192.168.1.41 after a user logs in to interface VTY 0.

<Sysname> system-view

[Sysname] user-interface vty 0

[Sysname -ui-vty0] auto-execute command telnet 192.168.1.41

% This action will lead to configuration failure through ui-vty0. Are you sure?

[Y/N]:y

[Sysname-ui-vty0]

# To verify the configuration, Telnet to 192.168.1.40.

The device automatically Telnets to 192.168.1.41, and the following output is displayed:

C:\> telnet 192.168.1.40

******************************************************************************

* Without the owner's prior written consent, *

* no decompiling or reverse-engineering shall be allowed. *

******************************************************************************

Trying 192.168.1.41 ...

Press CTRL+K to abort

Connected to 192.168.1.41 ...

******************************************************************************

* Without the owner's prior written consent, *

* no decompiling or reverse-engineering shall be allowed. *

******************************************************************************

<Sysname.41>

This operation is the same as directly logging in to the device at 192.168.1.41. If the Telnet connection to

192.168.1.41 is broken down, the Telnet connection to 192.168.1.40 breaks down at the same time.

command accounting

Use command accounting to enable command accounting.

Use undo command accounting to restore the default.