HP VPN Firewall Appliances Getting Started Guide
97
configure NTP for the device. For NTP configuration, see Network Management and Monitoring
Configuration Guide.
• With the modular method:
{ Every job can have only one view and up to 10 commands. If you specify multiple views, the
view specified most recently takes effect.
{ Enter a view name in its complete form. Most commonly used view names include monitor for
user view, system for system view, GigabitEthernet x/x for Ethernet interface view, and
Vlan-interfacex for VLAN interface view.
{ The time ID (time-id) must be unique in a job. If two time and command bindings have the same
time ID, the binding configured most recently takes effect.
Scheduling a job in the non-modular method
To schedule a job, execute one of the following commands in user view:
Task Command Remarks
Schedule a job.
• Schedule a job to run a command at a specific
time:
schedule job at time [ date ] view view
command
• Schedule a job to run a command after a delay:
schedule job delay time view view command
Use either command.
If you execute the schedule job
command multiple times, the most
recent configuration takes effect.
Changing any clock setting can
cancel the job set by using the
schedule job command.
Scheduling a job in the modular method
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Create a job and enter
job view.
job job-name N/A
3. Specify the view in which
the commands in the job
run.
view view-name
You can specify only one view for
a job. The job executes all
commands in the specified view.
4. Add commands to the
job.
• Configure a command to run at a
specific time and date:
time time-id at time date command
command
• Configure a command to run at a
specific time:
time time-id { one-off | repeating }
at time [ month-date month-day |
week-day week-daylist ] command
command
• Configure a command to run after a
delay:
time time-id { one-off | repeating }
delay time command command
Use any of the commands.
Changing a clock setting does not
affect the schedule set by using the
time at or time delay command.