HP VPN Firewall Appliances Getting Started Guide

134
Table 29 Command levels
Level
ID
Level
name
Default set of commands
0 Visit
Includes commands for network diagnosis and commands for accessing an external
device. Configuration of commands at this level cannot survive a device restart. Upon
device restart, the commands at this level are restored to the default settings.
Commands at this level include ping, tracert, telnet and ssh2.
1 Monitor
Includes commands for system maintenance and service fault diagnosis. Commands at
this level are not saved after being configured. After the device is restarted, the
commands at this level are restored to the default settings.
Commands at this level include debugging, terminal, refresh, and send.
2 System
Includes service configuration commands, including routing configuration commands
and commands for configuring services at different network levels.
By default, commands at this level include all configuration commands except for those
at manage level.
3 Manage
Includes commands that influence the basic operation of the system and commands for
configuring system support modules.
By default, commands at this level involve the configuration commands of file system,
FTP, TFTP, Xmodem download, user management, level setting, and parameter settings
within a system, which are not defined by any protocols or RFCs.
Changing the level of a command
Every command in a view has a default command level. The default command level scheme is sufficient
for the security and ease of maintenance requirements of most networks. If you want to change the level
of a command, make sure the change does not result in any security risk or maintenance problem.
To change the level of a command:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Change the level of a
command in a specific view.
command-privilege level level view
view command
See Table 29 for the default
settings.
Saving the running configuration
You can use the save command in any view to save all submitted and executed commands into the
configuration file. Commands saved in the configuration file can survive a reboot. The save command
does not take effect on one-time commands, including display and reset commands. One-time
commands are never saved.