HP VPN Firewall Appliances Getting Started Guide

29
Ste
p
Command Remarks
9. Specify the terminal display
type.
terminal type { ansi | vt100 }
By default, the terminal display type
is ANSI.
The device supports two types of
terminal display: ANSI and VT100.
HP recommends that you set the
display type of both the device and
the terminal to VT100. If the device
and the client use different display
types (for example, HyperTerminal
or Telnet terminal) or both are set to
ANSI, when the total number of
characters of the currently edited
command line exceeds 80, an
anomaly such as cursor corruption
or abnormal display of the terminal
display might occur on the client.
10. Configure the user privilege
level for login users.
user privilege level level
By default, the default command
level is 3 for the console user
interface.
11. Set the maximum number of
lines to be displayed on a
screen.
screen-length screen-length
By default, a screen displays 24
lines at most.
A value of 0 disables pausing
between screens of output.
12. Set the size of command
history buffer.
history-command max-size value
By default, the buffer saves 10
history commands at most.
13. Set the idle-timeout timer.
idle-timeout minutes [ seconds ]
The default idle-timeout is 10
minutes. The system automatically
terminates the user's connection if
there is no information interaction
between the device and the user
within the idle-timeout time.
Setting idle-timeout to 0 disables the
idle-timeout function.
Logging in through Telnet
NOTE:
Telnet login is not supported in FIPS mode.
You can Telnet to the device for remote management, or use the device as a Telnet client to Telnet to other
devices, as shown in Figure 31.
Figure 31 Telnet login