HP VPN Firewall Appliances Getting Started Guide

34
Ste
p
Command Remarks
10. Set a password.
password { cipher | simple }
password
By default, the password for
system-predefined user admin is
admin, and no password is set for any
other local user.
11. Specify the command
level of the local user.
authorization-attribute level level
Optional.
By default, the command level is 0.
12. Specify Telnet service for
the local user.
service-type telnet
By default, the system-predefined user
admin can use terminal service, Telnet
service, SSH service, and Web service,
and no service type is specified for any
other local user.
13. Exit to system view.
quit N/A
14. Configure common
settings for VTY user
interfaces.
See "Configuring common VTY user
interface setting
s (optional)."
Optional.
The next time you attempt to Telnet to the CLI, you must provide the configured login username and
password:
******************************************************************************
* Copyright (c) 2010-2013 Hewlett-Packard Development Company, L.P. *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
******************************************************************************
Login authentication
Username:admin
Password:
<HP>
If you are required to pass a second authentication, you must also provide the correct password to access
the CLI. If the maximum number of login users has been reached, your login attempt fails and the
message "All user interfaces are used, please try later!" appears.
Configuring common VTY user interface settings (optional)
You might be unable to access the CLI through a VTY user interface after configuring the auto-execute
command command on it. Before you configure the command and save the configuration, make sure you
can access the CLI through a different user interface.
To configure common settings for VTY user interfaces:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A