HP VPN Firewall Appliances Getting Started Guide

35
Ste
p
Command Remarks
2. Enter one or multiple VTY user
interface views.
user-interface vty first-number
[ last-number ]
N/A
3. Enable the terminal service.
shell
Optional.
By default, terminal service is
enabled.
4. Enable the user interfaces to
support Telnet, SSH, or both of
them.
protocol inbound { all | ssh |
telnet }
Optional.
By default, both Telnet and SSH
are supported.
The configuration takes effect the
next time you log in.
5. Define a shortcut key for
terminating tasks.
escape-key { default |
character }
Optional.
By default, pressing Ctrl+C
terminates a task.
6. Configure the type of terminal
display.
terminal type { ansi | vt100 }
Optional.
By default, the terminal display
type is ANSI.
7. Set the maximum number of lines
to be displayed on a screen.
screen-length screen-length
Optional.
By default, up to 24 lines is
displayed on a screen.
A value of 0 disables the function.
8. Set the size of command history
buffer.
history-command max-size
value
Optional.
By default, the buffer saves 10
history commands.
9. Set the idle-timeout timer.
idle-timeout minutes [ seconds ]
Optional.
The default idle-timeout is 10
minutes for all user interfaces.
The system automatically
terminates the user's connection if
there is no information interaction
between the device and the user
within the timeout time.
Setting idle-timeout to 0 disables
the timer.
10. Specify a command to be
automatically executed when a
user logs in to the user interfaces.
auto-execute command
command
Optional.
By default, no automatically
executed command is specified.
The command auto-execute
function is typically used for
redirecting a Telnet user to a
specific host. After executing the
specified command and
performing the incurred task, the
system automatically disconnect
the Telnet session.