HP VPN Firewall Appliances Getting Started Guide

Ste

Command

Remarks

15. Exit to system view.

quit N/A

16. Create an SSH user, and

specify the authentication

mode for the SSH user.

ssh user username service-type

stelnet authentication-type

{ password | { any |

password-publickey | publickey }

assign publickey keyname }

N/A

17. Configure common settings

for VTY user interfaces.

See "Configuring common VTY

user interface settings (optional)."

Optional.

Using the device to log in to an SSH server

You can use the device as an SSH client to log in to an SSH server. If the server is located in a different

subnet than the device, make sure the two devices have routes to reach each other.

Figure 34 Logging in to an SSH client from the device

Perform the following tasks in user view:

Task Command

Remarks

The server argument represents the IPv4 address or

host name of the server.

The server argument represents the IPv6 address or

host name of the server.

To work with the SSH server, you might need to configure the SSH client. For information about

configuring the SSH client, see Access Control Configuration Guide.

Local login through the AUX port

The following matrix shows the feature and hardware compatibility:

Hardware Com

atibilit

F1000-A-EI/F1000-S-EI No

F1000-E Yes

F5000 Yes

F5000-S/F5000-C No

VPN firewall modules No

20-Gbps VPN firewall modules No