HP VPN Firewall Appliances Getting Started Guide

66
Ste
p
Command Remarks
2. Enable the SNMP
agent.
snmp-agent
Optional.
By default, the SNMP agent is
disabled.
You can enable SNMP agent with this
command or any command that
begins with snmp-agent.
3. Configure an
SNMP group and
specify its access
right.
snmp-agent group v3 group-name
[ authentication | privacy ] [ read-view
read-view ] [ write-view write-view ]
[ notify-view notify-view ] [ acl acl-number
| acl ipv6 ipv6-acl-number ] *
By default, no SNMP group is
configured.
4. Add a user to the
SNMP group.
snmp-agent usm-user v3 user-name
group-name [ [ cipher ]
authentication-mode { md5 | sha }
auth-password [ privacy-mode { 3des |
aes128 | des56 } priv-password ] ] [ acl
acl-number | acl ipv6 ipv6-acl-number ] *
N/A
Configuring SNMPv1 or SNMPv2c access
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the SNMP
agent.
snmp-agent
Optional.
By default, the SNMP agent is
disabled.
You can enable SNMP agent with this
command or any command that begins
with snmp-agent.
3. Create or update
MIB view
information.
snmp-agent mib-view { excluded |
included } view-name oid-tree [ mask
mask-value ]
Optional.
By default, the MIB view name is
ViewDefault and OID is 1.