HP VPN Firewall Appliances Getting Started Guide

67
Ste
p
Command Remarks
4. Configure the
SNMP access
right.
• (Method 1) Specify the SNMP NMS
access right directly by configuring an
SNMP community:
snmp-agent community { read |
write } community-name [ mib-view
view-name ] [ acl acl-number | acl
ipv6 ipv6-acl-number ] *
• (Method 2) Configure an SNMP
group and add a user to the SNMP
group:
a. snmp-agent group { v1 | v2c }
group-name [ read-view
read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number |
acl ipv6 ipv6-acl-number ] *
b. snmp-agent usm-user { v1 |
v2c } user-name group-name [ acl
acl-number | acl ipv6
ipv6-acl-number ] *
Use either method.
The username with method 2 is
equivalent to the community name used
with method 1, and must be the same
as the community name configured on
the NMS.
SNMP login example
Network requirements
Configure the firewall and network management station so you can remotely manage the firewall
through SNMPv3.
Figure 55 Network diagram
Configuration procedure
1. Configure the firewall:
# Assign an IP address to the firewall. Make sure the firewall and the NMS can reach each other.
(Details not shown.)
# Enter system view.
<Sysname> system-view
# Enable the SNMP agent.
[Sysname] snmp-agent
# Configure an SNMP group.
[Sysname] snmp-agent group v3 managev3group