HP VPN Firewall Appliances Getting Started Guide

Item Descri

tion

Telnet

Specify whether to enable Telnet on the device.

Disabled by default.

HTTP

Specify whether to enable HTTP on the device, and set the HTTP port number.

Enabled by default.

IMPORTANT:

• If the current user has logged in to the Web interface through HTTP, disabling

HTTP or modifying the HTTP port number will result in disconnection with the

device. Therefore, perform the operation with caution.

• When you modify a port number, make sure the port number is not used by

another service.

HTTPS

Specify whether to enable HTTPS on the device, and set the HTTPS port number.

Disabled by default.

IMPORTANT:

• If the current user logged in to the Web interface through HTTPS, disabling

HTTPS or modifying the HTTPS port number will result in disconnection with

the device. Therefore, perform the operation with caution.

• When you modify a port number, make sure the port number is not used by

another service.

• By default, HTTPS uses the PKI domain default. If this PKI domain does not

exist, the system will prompt you for it when the configuration wizard is

completed. However, this does not affect the execution of other configurations.

7. Click Next.

The page for configuring interface IP appears.

The table lists the IP address configuration information for all Layer 3 Ethernet interfaces and VLAN

interfaces. You can click a value in the table and then modify it.